The general tab allows you to configure the following information.

Change the CFLink ID of the device by using the up and down arrows or by entering a number. The CFLink ID must be between 2 and 238. This number must also be unique on the CFLink network, if there is a CFLink conflict the SW16 will automatically assign the device a different ID.

In this tab you can also view the devices serial number, firmware version and MAC address.

The Reset Button restarts the device.

This is where you set the relevant values for testing the ports on your SW16.

Each SW16 port is capable of multiple functions. Each of these functions can be tested from this section.

Click each relevant button under your port heading to test this functionality subject to the settings chosen.

Each SW16 LED port is capable of multiple functions. Each of these functions can be tested from this section.

Click each relevant button under your port heading to test this functionality subject to the settings chosen.