This is an old revision of the document!
This is a software tool designed specifically for the DIN-RYx-N relay controller series. Among the features of this tool are automatic device discovery, device status, firmware update, general device settings, relay interlocks, setting different dry contact modes, macros/rules, user variables, serial port configuration and USB connection security.
There are 3 methods of connection available to the hardware - network(TCP Client), serial and USB. Click the “Connection Settings” option on the top-right corner of the window. Choose your method of connection and input the relevant connection details i.e. IP Address or Baud Rate Settings. Once connected, you will see the green colour connected status led.
There is also an optional Address Book for you to save all your commonly used connection details for quick recall and reconnection.
This area basically shows you all the general information and port status of the relay, load and dry contact on the device. It also shows available memory for macros, rules and user variables. Test buttons are also available here for testing the individual relay channels.
You can change the device ID by selecting the available ID from the drop-down selection and then clicking the Assign ID button. When changes happens on the device such as relay actions, AC Load and dry contact status - you can specify the mode for the feedback that comes back.
There are 2 feedback modes available - basic and verbose. Basic mode will only send details on the individual ports that are changed whereas verbose mode will send details on all ports every time a change to the ports are detected.