This shows you the differences between two versions of the page.
hardware:lan-bridge [2015/04/16 23:00] jarrod [Ethernet] |
hardware:lan-bridge [2015/04/16 23:01] (current) jarrod [Ethernet] |
||
---|---|---|---|
Line 48: | Line 48: | ||
<WRAP center round info 90%> | <WRAP center round info 90%> | ||
- | By default, the LAN Bridge is configured to communicate over both **UDP broadcasts** and **TCP Server** on port ''10207''. | + | By default, the LAN Bridge is configured to communicate over both ''**UDP broadcasts** and **TCP Server** on port **10207**''. |
</WRAP> | </WRAP> | ||
Line 57: | Line 57: | ||
* Communicating with third party RS232 devices such as projectors, TVs, etc. | * Communicating with third party RS232 devices such as projectors, TVs, etc. | ||
- | By default the LAN Bridge is configured to communicate directly with any connected serial device on TCP port 10208.\\ | + | <WRAP center round info 90%> |
+ | By default the LAN Bridge is configured to communicate directly with any connected serial device on ''TCP port 10208''.\\ | ||
The LAN Bridge must be set to RS232 mode first (by using the setup button on the top of the LAN Bridge, or via the System Commander configuration software). | The LAN Bridge must be set to RS232 mode first (by using the setup button on the top of the LAN Bridge, or via the System Commander configuration software). | ||
+ | </WRAP> | ||
+ | |||
=== Socket and Cable Pinouts === | === Socket and Cable Pinouts === |