CommandFusion Wiki

Documentation Resources

User Tools

Site Tools


software:gui-designer:system-manager:system-properties

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

software:gui-designer:system-manager:system-properties [2014/11/07 15:01]
jarrod [Ports]
software:gui-designer:system-manager:system-properties [2015/01/29 05:57] (current)
jarrod [Ports]
Line 24: Line 24:
 The destination port is the port number the external system is accepting connections on, whilst the origin port is the port number that iViewer is sending messages from. Some systems require commands to be sent to a specific port, but replies are sent on a different port (common amongst UDP systems mainly).\\ The destination port is the port number the external system is accepting connections on, whilst the origin port is the port number that iViewer is sending messages from. Some systems require commands to be sent to a specific port, but replies are sent on a different port (common amongst UDP systems mainly).\\
 You only have to enter the '​Port'​ setting most of the time (the origin port will use the destination port setting if it is not explicitly set).\\ You only have to enter the '​Port'​ setting most of the time (the origin port will use the destination port setting if it is not explicitly set).\\
-The port numbers must be in the range 1 to 65535. See http://​www.iana.org/​assignments/​port-numbers for more details on port number usage in general.+The port numbers must be in the range 1 to 65535. See http://​www.iana.org/​assignments/​port-numbers for more details on port number usage in general.\\ 
 +**Note that you cannot use UDP ports below 1024 on Android platform. This is a limitation of Android.**
  
 === For UDP systems === === For UDP systems ===
software/gui-designer/system-manager/system-properties.1415372500.txt.gz · Last modified: 2014/11/07 15:01 by jarrod