CommandFusion Wiki

Documentation Resources

User Tools

Site Tools


hardware:modular-base-units:din-mod4

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

hardware:modular-base-units:din-mod4 [2012/08/22 15:17]
jarrod [CFLink x 2]
hardware:modular-base-units:din-mod4 [2013/09/02 03:45] (current)
aaron [Module Slots]
Line 1: Line 1:
 ====== DIN-MOD4 ====== ====== DIN-MOD4 ======
  
-The CommandFusion DIN-MOD4 is a modular controller, capable of housing 4 modules, in any combination.\\+The CommandFusion DIN-MOD4 is a DIN-Rail mountable ​modular controller, capable of housing 4 modules, in any combination.\\
 You could for instance load it up with 4 IR modules, giving a total of 32 IR ports. Or perhaps 4 COM4 modules, giving a maximum of 17 RS232 ports (including the on-board RS232 port).\\ You could for instance load it up with 4 IR modules, giving a total of 32 IR ports. Or perhaps 4 COM4 modules, giving a maximum of 17 RS232 ports (including the on-board RS232 port).\\
  
Line 67: Line 67:
 ==== On-Board Digital Input ==== ==== On-Board Digital Input ====
  
-This digital input can be used to trigger rules in the CFLink network.\\ +This dry contact ​digital input can be used to trigger rules in the CFLink network.\\ 
 +  - Input 
 +  - Ground
 ==== CFLink x 2 ==== ==== CFLink x 2 ====
  
Line 95: Line 96:
 After inserting a module, you will need to reset the DIN-MOD4 before that module is detected.\\ After inserting a module, you will need to reset the DIN-MOD4 before that module is detected.\\
  
 +==== Module Pinouts ====
 +You can find [[hardware:​modules|documentation for each module]] and the relevant page in our [[hardware:​modules|modules section]].
 +===== Factory Reset =====
 +For information on how to rest your device to factory settings, see the [[hardware:​device-resetting|Device Resetting Page]].
hardware/modular-base-units/din-mod4.1345648656.txt.gz · Last modified: 2012/08/22 15:17 by jarrod