Differences

This shows you the differences between two versions of the page.

--- hardware:modular-base-units:din-mod4 [2012/08/22 15:17]
jarrod [CFLink x 2]
+++ hardware:modular-base-units:din-mod4 [2013/09/02 03:45] (current)
aaron [Module Slots]
@@ Line 1: / Line 1: @@
 ====== DIN-MOD4 ======
-The CommandFusion DIN-MOD4 is a modular controller, capable of housing 4 modules, in any combination.\\
+The CommandFusion DIN-MOD4 is a DIN-Rail mountable modular controller, capable of housing 4 modules, in any combination.\\
 You could for instance load it up with 4 IR modules, giving a total of 32 IR ports. Or perhaps 4 COM4 modules, giving a maximum of 17 RS232 ports (including the on-board RS232 port).\\
@@ Line 67: / Line 67: @@
 ==== On-Board Digital Input ====
-This digital input can be used to trigger rules in the CFLink network.\\
+This dry contact digital input can be used to trigger rules in the CFLink network.\\
+  - Input
+  - Ground
 ==== CFLink x 2 ====
@@ Line 95: / Line 96: @@
 After inserting a module, you will need to reset the DIN-MOD4 before that module is detected.\\
+==== Module Pinouts ====
+You can find [[hardware:modules|documentation for each module]] and the relevant page in our [[hardware:modules|modules section]].
+===== Factory Reset =====
+For information on how to rest your device to factory settings, see the [[hardware:device-resetting|Device Resetting Page]].

CommandFusion Wiki