Differences

This shows you the differences between two versions of the page.

--- hardware:lan-bridge [2014/01/09 04:16]
aaron
+++ hardware:lan-bridge [2015/04/16 23:01] (current)
jarrod [Ethernet]
@@ Line 47: / Line 47: @@
 The supplied Ethernet cable can be used to place the LAN Bridge on your local network.
-By default, the LAN Bridge is configured to communicate over both UDP broadcasts and TCP Server on port 10207.
+<WRAP center round info 90%>
+By default, the LAN Bridge is configured to communicate over both ''**UDP broadcasts** and **TCP Server** on port **10207**''.
+</WRAP>
 ==== RS232 ====
 The RJ12 port is used to communicate to and from RS232 devices.\\
@@ Line 54: / Line 57: @@
   * Communicating with third party RS232 devices such as projectors, TVs, etc.
-By default the LAN Bridge is configured to communicate directly with any connected serial device on TCP port 10208.\\
+<WRAP center round info 90%>
+By default the LAN Bridge is configured to communicate directly with any connected serial device on ''TCP port 10208''.\\
 The LAN Bridge must be set to RS232 mode first (by using the setup button on the top of the LAN Bridge, or via the System Commander configuration software).
+</WRAP>
 === Socket and Cable Pinouts ===
@@ Line 106: / Line 112: @@
 ===== LAN Bridge Configuration =====
-Click here to learn more about configuring the LAN Bridge.
+[[hardware:lan-bridge:lan-bridge-configuration|Click here to learn more about configuring the LAN Bridge.]]

CommandFusion Wiki