You can find the results of your search below. If you didn't find what you were looking for, you can create or edit the page named after your query with the appropriate tool.
==== Common Device Protocol ======
The following CFLinkprotocol messages are common to all CFLink devices.
=====... cation settings for the on-board serial port of a CFMini on CFLink ID [05]
> [F2][05][F3]QMINTGT[F4][F5][F5]
// Repl... rd serial port and dry contact input of a MOD4 on CFLink ID [03]
> [F2][03][F3]QMODTGT[F4][F5][F5]
// Repl... he ''DID'' (Device ID) command is used to set the CFLink ID of a specific device.
=== Data ===
The data
2 Port Protocol ======
This document defines the CFLinkprotocol for working with the on-board serial port found o... Send a command out the on-board serial port of a CFMini on CFLink ID [03]
> [F2][03][F3]TMINSPW[F4]Hello World!\x0D... turn is received on the on-board serial port of a CFMini on CFLink ID [03].
// The CFMini is configured to send incoming RS232 data to CFLink ID's [02], [04] and [07]
< [F2][02][F3]RMINSPR[F4]Hello World!\x
d the CF Mini Quick Reference Guide here.]]
===== CFLinkProtocol =====
For details on the CFLinkprotocol supported by the CF Mini, see the [[hardware:cflink:cf-mini-cflink-protocol|CF Mini CFLinkProtocol page]].
===== Information Panel =====
The inform... ware missing
* Solid = Power on and ready
* CFLink Fault (Red)
* Solid = Fault discovered on CFLink bus. Remain solid until reset.
* Reset unit to clear CFLink fault flag and turn off LED.
*
document outlines all error codes reported by the CFLinkprotocol.
===== 001 - 074: Common Error Codes =====
The ... Rule definitions.
* 001 = Does not comply with CFLink format
* 002 = Command not recognised
* 003 =... = Invalid Payload Field
* 006 = Invalid ''TGT'' CFLink ID
* 007 = Duplicate ''TGT'' CFLink ID Defined
* 008 = ''TGT'' CFLink ID is local CFLink ID
* 009 = ''DID'' Invalid CFLink ID
* 010 = ''DID''
ich equals decimal ID value of 32.
Throughout the protocol all CFLink ID's are referred to in hex format (or ascii representation of hex). The decimal value is not needed anywhere in the protocol.