Differences

This shows you the differences between two versions of the page.

--- hardware:cards:card-dali2 [2015/07/16 03:33]
jarrod created
+++ hardware:cards:card-dali2 [2015/07/16 04:39] (current)
jarrod
@@ Line 2: / Line 2: @@
 This card adds DALI capability to the [[hardware:solo|Solo controller]].\\
 It features 2 x DALI channels/loops, with up to 64 devices per channel (128 total DALI addresses).\\
-Also on-board are 2 x dry contact inputs, which can be used to trigger rules on the Solo, including but not limited to triggering DALI lighting commands.\\
+Also on-board are 2 x dry contact inputs, which can be used to trigger rules on the [[hardware:solo|Solo]], including but not limited to triggering DALI lighting commands.\\
-The card can supply power to the DALI bus if the Solo is powered by the 2-pin connector only. If powering the Solo via USB, the CARD-DALI cannot supply power to the DALI bus.
+The card can supply power to the DALI bus if the [[hardware:solo|Solo]] is powered by the 2-pin connector only. If powering the [[hardware:solo|Solo]] via USB, the CARD-DALI cannot supply power to the DALI bus.
 ===== Pinout =====
 The card is supplied with 2 x 6-pin spring terminal connectors.\\
 Pinout is as follows (top left to bottom right):
-  - P01 DA A
+  - P01 DA +
-  - P01 DA B
+  - P01 DA -
   - P01 DA Loop-through
   - P01 DA Loop-through
   - P01 Dry Contact Input COM
   - P01 Dry Contact Input GND
-  - P02 DA A
+  - P02 DA +
-  - P02 DA B
+  - P02 DA -
   - P02 DA Loop-through
   - P02 DA Loop-through

CommandFusion Wiki